NuTone CI370 Manual de usuario descargar pdf

CENTRAL CLEANING SYSTEM

Indicating Inlets

MODELS: CI370 Series

USE ONLY WITH CV653, CV750 & CV850 POWER UNITS

Mounting Bracket

MODEL: 361

INSTALLATION

1. Once the locations for wall inlet locations have been

determined, mount all inlet brackets.

2. To locate bracket on wall stud, measure approximately 18" up

from finished floor level. (Height location may vary according to

individual preference.)

3. Refer to Figure 1. Nail bracket to side of stud so that front

edge of bracket is flush to front of stud. (The bracket may also

be nailed to the front edge of the stud. For front stud mounting,

use locating tabs on bracket for proper alignment.)

4. Refer to Figure 2. Remove cardboard from plaster guard

frame. Using four (4) provided screws, attach the appropriate

flanged fitting and inlet seal to back of inlet.

5. Replace cardboard into plaster guard frame.

6. Plumb tubing to inlet. Run 2-conductor (376 or 376UL)

low voltage cable between inlet and power unit.

CAUTION: When tubing is run through the wall stud, sole

plate, headers – or anywhere that building materials will be

attached – place a nail plate (Model 378) over that area (on

both sides if necessary) to prevent nails from piercing tubing.

WALL INLET INSTALLATION

1. Once the walls have been finished, install the wall inlets.

2. Remove the cardboard plaster guard.

3. Refer to Figure 3. For some dry wall or panel construction,

the plaster frame will extend beyond the finished wall. In this

case, remove plaster frame from mounting bracket by

removing mounting screws.

NOTE: When using the Model 361 inlet bracket on walls

thinner than

⁄2", use a

⁄4" spacer (not furnished) between

the wall and the inlet bracket. See Figure 3A.

Spacer may be made from plywood, Masonite™, etc. Contact

cement may be used to hold spacer in place during assembly.

Configuration of spacer may vary depending upon installation.

INSTALLATION INSTRUCTIONS

READ & SAVE THESE INSTRUCTIONS!

FIGURE 1

FIGURE 2

MODEL 361

SIDE

MOUNTING

FACE

MOUNTING

FIGURE 3

/4"

INLET MOUNTING

BRACKET

SPACER

WALL LESS THAN

/2" THICK.

PLASTER

GUARD

HOLE

FIGURE 3A

1 2 3 4

Indice de contenidos

Pagina 1 - Mounting Bracket

CENTRAL CLEANING SYSTEMIndicating InletsMODELS: CI370 SeriesUSE ONLY WITH CV653, CV750 & CV850 POWER UNITSMounting BracketMODEL: 361INSTALLATION1.

Pagina 2 - FINAL SYSTEM CHECK

Product specifications subject to change without notice.4820 Red Bank Road, Cincinnati, Ohio 45227 • 1140 Tristar Drive, Mississauga, Ontario, Canada

Pagina 3 - Cadre De Montage

SYSTÈME D’ASPIRATION CENTRALPrises Avec VoyantMODÈLE: CI370 SeriesUTILISER SEULEMENT AVEC LES APPAREILS CV653,CV750 et CV850Cadre De MontageMODÈLE: 36

Pagina 4

Les caractéristiques de produits peuvent changer sans préavis.4820 Red Bank Road, Cincinnati, Ohio 45227 • 1140 Tristar Drive, Mississauga, Ontario, C

Comentarios a estos manuales

Sin comentarios

NuTone CI370 Manual de usuario

Busca en linea o descarga Manual de usuario para No NuTone CI370. NuTone CI370 User's Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para No NuTone CI370